EN
INSTALLATION AND USER MANUAL
•
Make sure that the mains voltage is the same as indicated in the
•
When installing in a room with a bath or shower, respect the "protec-
security directives.
•
•
For models that do not have a plug, it is necessary to install a suita-
ble omnipolar switch to ensure complete disconnection if necessary.
•
WARNING! Do not rotate the device.
•
Do not cover the equipment control with any towel.
•
Connect the energy cable.
tion yourself so that the control is out of this space. Under no circumstances can it be placed within
volume 1.
•
Place the electric towel rail against the wall in the desired position.
•
Using a pencil, mark your position on the wall around the support tubes. Make sure there is no
wiring in the wall where you are going to drill.
•
With the help of a suitable drill and drill, drill the holes in the tile / wall to the required depth.
•
Important: the holes must be drilled correctly aligned and appropriate to the diameter of the
block and the length of the wall anchor bolts.
•
support of the electric towel rail.
•
the brackets with the anchor bolts.
Voltage supply
IP grade
Selectable power range
Conformity marking
Operating temperature
F. Functions
6 modes: Comfort, Night, Frost, Chrono, Timer-2h and Stand-by.
•
"Comfort" mode: the electronic control maintains the temperature at the value selected by the
user for this mode.
•
"Night" mode: the electronic control keeps the temperature at a lower value than the "Comfort"
temperature selected for this mode.
•
"Frost" mode: the electronic control maintains the ambient temperature above 7°C.
•
"Timer 2h" mode: the electronic control keeps the heating element on for a period of 2 hours
regardless of the set temperature. At the end of the 2 hour period the device returns to the
previous operating mode. For safety reasons, during the two hours of this period of time, the
•
"Chrono" mode: the electronic control works according to a daily / weekly program. The pro-
230VAC - 50Hz
IP44
7ºC ÷ 32ºC
CE
-10ºC ÷ +40ºC
6
-