Introduction - Termat MTPCR500T Installationsanleitung Und Gebrauchsanleitung

EN
INSTALLATION AND USER MANUAL
A. Introduction
The towel rail incorporates a digital chronothermostat for automatic temperature control. By means of an
and simple design, suitable for all types of environments.
VERY IMPORTANT
Read the installation and use manual before assembling and operating the equipment.
Observe the warnings carefully.
Install the equipment in a place where air can circulate.
WARNING RISK OF ELECTRIC SHOCK!
• Pay attention to this instruction sheet and read carefully before
using the device.
•
• The thermostat is designed to heat the liquid contained within the
towel dryer in combination with a heating element. Any other use
is prohibited.
• Do not use the towel rail for drying garments of synthetic or acrylic
You must check before placing towels or other type of garment,
that this is capable of withstanding high temperatures.
• In the towel rack can reach up to 95°C temperature as long as
there are towels covering a tube.
• When using the towel rack for towel drying, try not to place more
than 2 in the case of towel rails whose powers are between 300-
450W or more than 4 in the case of towel rail whose powers are
between 500-1200W and that these are not superimposed, that
is, one on top of the other.
• Avoid placing the towels on the wall supports.
• Before using, make sure that the line voltage is the same as the
• Only use heating elements compatible with the type of dry towels
used.
•
and do not handle it. Damaged power cables can be replaced
•
4