Inhaltsverzeichnis
Werbung
Combi Input 1
Volume
Combi Input 2
Volume
AUX IN
(3.5 Stereo jack)
Run all cables neatly, use cable ties to tidy excess cable length in 'figure-8' not
loops.
Use electronic safety devices such as circuit breakers. Start with EQ settings flat and
gains low.
Master volumes should be at zero for switch on and off.
Use the minimum cut or boost in EQ. If all bands are boosted or cut, flatten EQ, re-
adjust gain and start again.
Use input gain to set maximum signal level without distortion (use VU meters, bar
graphs or peak lights). Amps should have peak or clip lights illuminating only on signal
peaks, not all the time.
Set up mic levels first, and adjust other equipment to match.
Avoid very high onstage levels from backline amps.
When using separate power amps, turn the level of the amp to maximum. Control
overall level from your mixer, not the power amp.
Avoid damp environments and extremes of temperature for storage and use of all
audio equipment.
Look after your cables. Do not stand equipment or run cases over them, do not tie
knots in them and always use them for the correct application (a signal lead is NOT a
speaker lead). Coil and secure with cable ties before storing.
Ensure your equipment is properly loaded and cannot move around during
All manuals and user guides at all-guides.com
38Hz
BLOCK DIAGRAM
Mix Link Out
Limiter
EQ
Preshape
Peak
12
Internal
HF Driver
200W Class D
Passive
Power amplifier
2 way
crossover
Internal
Woofer
Protection
Circuit
transit.
Werbung
Inhaltsverzeichnis
