Inhaltsverzeichnis
Werbung
Unpacking
Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging materials.
Should you ever need to return the unit back to the dealer or HH Electronics, use only
the original factory packing.
Basic Setup
HH Red active cabs can be mounted on the floor, a suitable pole or tripod, or flown
(See safety note below). Connect a suitable mains lead to the mains inlet on the rear
panel, and a line level signal to the input. Set the level controls to minimum before
switching on.
Switching Off
After using the amplifier, please adjust the gain level controls to their lowest settings,
then the amplifier can be turned off safely. Turn the power switch to the OFF position
and remove the power cord from the electrical source.
NOTE:
Do not connect or disconnect from the input signal source when the amplifier is turned
ON, damage could occur to the amplifier and the speaker.
If the amplifier is in standby mode without use for over 3 hours, remove the power
cord from the electrical source.
All speakers should be balanced and steady. If stacked strap them together to
improve stability.
Don't overextend poles/tripods; ensure at least 4 x the pole diameter is still inside
the outer pole.
Make sure the legs have a good splay on tripods, but do not obstruct doorways or
other access-ways
Ensure the top cab is smaller/lighter than bottom if using a pole.
Keep lights away from speakers; heat can cause fires / speaker damage.
Don't run cables across access-ways; if you have to, run them above doors or use
approved cable covers.
HH Red cabinets are fitted with M8 flying points for installation and suspended use
in horizontal and vertical orientations.
Note that suspension or 'flying' of cabinets should be performed only by
properly qualified persons, in compliance with all local laws and using
approved hardware'.
Be aware of total power usage. Overloading a mains socket is potentially
dangerous, and likely to cause a power out during use.
Keep lighting cables away from ALL sound cables including mains, use separate
circuit for lights if possible. Keep power and signal cables apart
All manuals and user guides at all-guides.com
USEFUL HINTS AND TIPS
Werbung
Inhaltsverzeichnis
