Connecting The Base Station; Connecting The Charging Station; Inserting The Batteries; Charging The Batteries - AUDIOLINE WAVE 10X ECO Bedienungsanleitung

Connecting the base station

Attention: Position the base station at least 1 m away from other
electronic devices, otherwise there is a risk of mutual disturbance.
Connect the base station as illustrated in the diagram. For reasons
of safety, only use the power adapter plug and telephone connec-
tion line supplied.
Telephone line socket
Attention: With regard to the base station, use the power
adapter plug, model No. ED3514065030P bearing the
output data: 6,5 V, 300 mA.

Connecting the charging station

Connect the charging station as
illustrated in the diagram. For
safety reasons, only use the
power adapter plug supplied.
Attention: With regard to the charging station, use the power
adapter plug, model No. SA 28−146 bearing the
output data: 6,5 V, 150 mA.

Inserting the batteries

Insert the batteries in the open battery
compartment. Only use batteries of
the type AAA NiMH 1,2 V.
Pay attention to correct polarity.
Close the battery compartment.

Charging the batteries

Before the handset is used for the first time, insert it in the base/
charging station for at least 24 hours.
When the handset is inserted in the base/charging station properly,
you will hear an acoustic confirmation signal. The handset warms
up during the charging process. This is normal and does not repre-
Only applies to telephone sets with at least two handsets .
1
Section Package contents" on Page 21.
22
Service−Hotline Germany: Tel. 0180 5 001388 (cost via Telekom at time of going to print: 14 ct/min)
Mains power outlet
10
1
Mains power outlet