Safety Instructions; Assembly, Disassembly - Sunjoy A102007003 Aufbauanleitung & Nutzungshinweise

IMPORTANT
Before you start assembling the product, read the instructions carefully.
Follow the order of the steps as shown in the assembly instructions.
Keep the instructions in a safe place for later reference.

SAFETY INSTRUCTIONS

•
Please follow safety instructions listed below and keep them for later use.
•
Before assembling or using the product, remove the packaging material or keep it to store the product for
the winter.
•
This product should only be used in a non-commercial manner.
•
For safety reasons, we recommend that a minimum of two people assemble the product. Keep children
away.
•
Warning - Keep plastic bags and small spare parts out of the reach of children. Thin film may stick to
nose and mouth and prevent breathing. Danger of suffocation.
•
Some parts have metal edges, so wear protective gloves during assembly.
•
The product should be mounted on a solid base, preferably on concrete footings or in paving. This will
prevent wind damage or damage to other property or health. If the product cannot be securely and firmly
attached, it must be dismantled and stored before the wind arrives.
•
Do not climb or stand on the roof of the product. Do not hang or support heavy objects on the
structure. The product may collapse.
•
The product has not been tested for wind and snow loads. These loads are therefore not covered by the
warranty. Watch the weather forecast to properly protect or disassemble the product in a timely manner
and store.
•
The product with a fabric roof must be dismantled and stored before winter (snow) arrives. Especially
large amounts of snow could damage the roof.
•
Keep the roof and eaves free of snow, dirt and leaves.
•
Products should only be used temporarily and dismantled in adverse weather conditions.
•
Make sure you keep a sufficient distance from houses and power lines to avoid possible damage.
•
When using suitable heaters, keep them at a minimum distance of 1.2 m from the fabric. Under no
circumstances should open flames or open flame heaters such as patio heaters, gas heaters, etc. be
used inside the product.
•
The manufacturer is not liable for any damages resulting from failure to follow these instructions
and recommendations.

ASSEMBLY, DISASSEMBLY

CAUTION: Be careful not to injure anyone during assembly, especially when lifting heavy parts.
Remove the individual parts and check them against the parts list shown to see if anything is missing.
Resolve any differences with the seller immediately.
The person in charge of the construction of the product is responsible for ensuring that it is sufficiently
secured to ensure safety. Keep checking the fixing afterwards to ensure that it has not been damaged.
Stable anchoring can extend the life of the product.
Please allow extra time for the initial installation of the product. It should be assembled by at least two
adults. Select a flat and level surface suitable for the assembly of the product and its intended use. The
fabric should not come into contact with any objects with sharp edges. The screws connecting the tubes
to the connectors must be tightened by hand using a hex key or an automatic screwdriver set to a
maximum level of 2 to prevent damage to the parts.
Metal parts are coated with a thin layer of preservative oil. Some parts may have more lubricant than
normal. In this case, use a cloth to remove the excess oil.
For your own safety, wear a helmet, gloves, and sturdy shoes. Metal parts could have sharp edges and
possibly be greasy.
EN PAVILLONS, PERGOLAS & GAZEBOS