Possible Cause - HOMCOM Mercedes-AMO GT R Bedienungsanleitung

Problem
Car does not move
12
Car was running but
suddenly stopped
Troubleshootin g

Possible Cause

Circuit breaker tripped
Loose wire or connectors
Dead battery
Undercharged battery
Charger is not working
Damaged switch
Loose wire or connectors
Circuit breaker tripped
Solution
Circuit breaker may "trip" and stop the vehicle if it is overloaded or the
driving conditions too severe. The breaker will automatically reset after
approximately 10 seconds, and the vehicle will operate normally. To avoid
repeated automatic shut downs, do not overload the vehicle by exceeding
the weight limited of 25kg (55 lbs). Or by towing anything behind the vehicle.
Do not drive up hills or run into fixed objects, which can cause the wheels to
stop spinning while power is still being supplied to the motors.
Check all wires and connectors. Make sure that the motor harness
connector is plugged in tightly to the battery, and that there are no
loose wires around the motor.
An old or improperly cared battery may be dead. If you are unsure
whether it is dead or not, you can have it tested at your Service
Center.
A new battery should have been charged for at least 12 hours before
using the vehicle for the first time. After that, it must be recharge the
battery for at least 8-10 hours after each use. Never charge longer than
24 hours. Check all connectors; make sure the charger is plugged into
the wall. Make sure the power flow to the outlet is on.
You must have a volt meter in order to tell whether the charger is
working or not. If you think there maybe a problem with the charger ,
take it to the Service Center where they will test it for you.
When exposed to water or moisture, switches can become corroded,
or can jam due to loose dirt, sand or gravel.
Contact your Service Center for diagnosis and repair.
Check all wires and connectors. Make sure that the motor harness
connector is plugged into the battery tightly, and that there are no
loose wires around the motor.
Circuit breaker may utrip" and stop the vehicle if it is overloaded or
the driving conditions too severe. The breaker will automatically
reset after approximately 10 seconds, and the vehicle will operate
normally. To avoid repeated automatic shutdowns, do not overload
the vehicle by exceeding the weight limited of 25kg (55 lbs),or by towing
anything behind the vehicle. Do not drive up hills or run into fixed
objects, which can cause the wheels to stop spinning while power
is still being supplied to the motors. If breaker continually trips,
contact your Service Center.