Philips Avance Collection HR3657/90 Benutzerhandbuch Seite 7

5 Safety protection
The blender has a safety protection
system. When Blender run over
3 minutes at a time, it will stop process
automatically. If you have not finished
processing after 3 minutes, switch off
the appliance and let it cool down
to room temperature. Never use over
3 minutes consecutively.
When assembling the blender jar, make
sure that the rotary knob is pointing to
OFF first.
Do not attempt to process very thick
recipes such as bread dough or mash
potatoes.
6 Using your
blender
Using the blender jar
(Fig. 2)
To process ingredients briefly (such as
garlic), press and hold the
To make a smoothie, press the
button. To stop, turn the rotary knob to
the OFF position.
To crush ice, press the
the rotary knob to the OFF position.
Note
•
After 1 minute, the blender will stop the
process automatically.
•
Do not blend dry ingredients (for example
pepper corn or star anise).
Using the tumbler jar
(Fig. 3)
Make your smoothies or shakes directly
with the tumbler. Remove the blade unit
and attach the lid of the tumbler. Then
you can bring the tumbler out and enjoy
directly.
Using the spatula (Fig. 4)
When the blender is switched on, use
the spatula to enhance the smoothness
and consistency of result.
When the blender is switched off,
use the spatula to remove the sticky
ingredients on the jar.
Using the mill (Fig. 5)
button.
You can use the mill to grind and chop
ingredients such as coffee beans,
peppercorns, sesame seeds, rice,
wheat, coconut flesh, nuts (shelled),
button. turn
dried soy beans, dried peas, cheese,
breadcrumbs, etc.
Note
•
Never overfill the tumbler jar above the
maximum level indication to avoid spillage.
•
Never fill the tumbler jar with soft drinks to
avoid spillage.
Note
•
The mill is not suitable for chopping very hard
ingredients like nutmeg and ice cubes.
•
Do not use the mill to process liquids such as
fruit juice.
•
Do not process ingredients more than the mill
jar's MAX mark.
•
Never fill the mill with hot ingredients.
•
You can order a mill (HR3650) from your
Philips dealer or a Philips service center as an
extra accessory.
EN
11