Set The Batteries In The Call Button - Extel WECR 70305 Installations- Und Bedienungsanleitung

CHARACTERISTICS
No wiring - Operates on a mains outlet
Range: up to 50 metres between call button and chime.
5 selectable ringtones
KIT COMPRISING
Plug-in wireless chime (230 V AC) CRRC 70305 SER.R1
Call button transmitter (uses 12 V battery, type A23, included) CREM 87000 SER.R1
Rain shield
Bag of attachment screws
Note : as with all wireless chimes, the transmission range will be reduced if the signal passes through several walls or ceilings.
Please read and follow these instructions to ensure satisfactory use.

SET THE BATTERIES IN THE CALL BUTTON

Take off the upper side of the call button with a flat screwdriver. (pics 1-2)
Open the protective device et install correctly battery by respecting the polarity (pic 3)
You can change the microswitch position if necessary (see following chapter)
Close back the call button and check that the set is correctly functioning
Don't forget to set back the plastic protective casing device which guarantees the printed circuit protection.
All manuals and user guides at all-guides.com
The chime must be placed indoor, on a conform electric installation,
and in a room free from moisture
CFI EXTEL WECR 70305 SER.R1 - 05/2011 - V1
3GB