Inhaltsverzeichnis
Werbung
EN
3M™ PELTOR™ Adapter FL5000 series
FL5*
*Designates a product variant
1.
INTRODUCTION
Congratulations and thank you for choosing this
communication solutions adapter!
1.1. INTENDED USE
This adapter connects and provides Push-to-Talk (PTT)
functionality between PELTOR communication headsets
and selected two-way radios.
It is expected that all users read and understand the
provided user instructions as well as be familiar with the
use of this device.
2.
SAFETY
2.1. IMPORTANT
Please read, understand, and follow all safety
information in these instructions prior to use. Retain
these instructions for future reference. For additional
information or any questions, contact 3M Technical
Services (contact information listed on the last page).
!
WARNING
Failure to follow these instructions may result in
serious injury or death:
To reduce the risks associated with igniting and
explosion, do not use non-intrinsic safe products and
accessories in a potentially explosive atmosphere.
3.
CAUTION
•
Always use product-specific 3M™ PELTOR™
replacement parts. Use of unauthorized replacement
parts may reduce the protection you receive from this
product.
3.1. NOTE
•
Operating temperature range: -20°C (-4°F) to 50°C
(122°F).
4
4.
APPROVALS
Hereby, 3M Svenska AB declares that the FL5000 series
is in compliance with the essential requirements and
other provisions set out in the appropriate Directives and
Regulations.Thereby it fulfils the requirements for CE
and/or UKCA marking.
The part number of your adapter can be found at the
back side of the adapter. An example can be seen in the
picture below.
A copy of the DoC and additional information required in
the Regulations and Directives can also be obtained by
contacting 3M in the country of purchase.
For contact information, see last pages of this User
Instruction.
5.
OVERVIEW
(Figure A)
A:1 Attachment clip
A:2 Loop
A:3 PTT button
A:4 Connector cord
A:5 Headset contact
A:6 Internal/external switch (if supplied)
6.
OPERATING INSTRUCTIONS
6.1. OPERATION
(
Figure A)
1. Connect the headset to the adapter and the adapter
to the two-way radio.
2. Switch the two-way radio on and adjust the volume to
the desired level.
3. Keep the PTT button pressed while transmitting.
4. If necessary, use switch (A:6) for external and
internal sound.
NOTE: The jack is at a 10° angle to the outgoing cord!
Werbung
Inhaltsverzeichnis
