Safety Requirements; Contents Of The Package; Technical Specifications; Before Assembly - DALAP ROV-300 Gebrauchsanweisung

The controller is intended for the easy control of the rotation speed of a fan or similar products.
The controller must be placed in a junction box (box for the installation of a circuit breaker).
The controller must be installed by a qualified professional (electrician) after carefully reading the product manual, and
installation must conform to safety standards.
CAUTION!
The controller's contacts are under voltage. During installation, maintenance, repair and setting, the controller must be
disconnected from the main source of voltage.
The original packing contains:
• 1 controller
• User's Manual
• Original packaging
The ambient air must not contain explosive and corrosive particles.
Model Voltage (V)
ROV-300
230
ROV-400
The controller must be installed on a vertical wall into a flush-mounted or external junction box indoors.
To ensure safe installation and operation, it is necessary to prevent:
• penetration of water or rain drops
• access of direct sunlight
• placing the controller near heat sources and heating
The controller must be connected by means of connectors, the minimum distance between the contacts of which
should be 3 mm, and using a terminal board.
Connection must be made based on the diagram shown in PIC. 2.
Use

Safety requirements

Contents of the package

Technical specifications
Maximum
Frequency
output
(Hz)
power (W)
300
50 / 60
400

Before assembly

3
Degree of
Weight (kg)
protection
0.11
IP 40
0.25
Dimensions Maximum
(mm) load (A)
95×85×60 1.5
78×78×63 1.8
EN EN EN