Maintenance And Storage - KRATOS SAFETY FA 60 039 XX Bedienungsanleitung

The equipment must be systematically checked if in doubt or after a fall, and at least every twelve months by the manufacturer or a competent person*,
in strict compliance with the manufacturer's periodic inspection procedures (in particular Inspection Guides ref. GI XXXXXXXX-XX), to make sure it
is well preserved and therefore ensure the user's safety. The data sheet must be completed (in
writing) after each inspection. The date of inspection and date of the next inspection must be indicated on the data sheet. We also
recommend marking the date of the next inspection on the equipment.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
MAINTENANCE AND STORAGE: (These instructions must be strictly observed)
Use a damp cloth (not dripping wet) to remove dust or other contaminants from the housing. Do not use any abrasive agents or solvents.
Use a soft bristle brush to remove dust or other contaminants from safety cables. Do not use a wire brush. Do not use petrol or solvents.
Never immerse in water or store outdoors. The device must be stored in a cool, dry and well ventilated area away from open flames and heat sources,
ideally in its original packaging.
During transportation, keep the equipment away from any cutting edges and keep it in its packaging.
18