Operating Instructions - LG AMNH09GB1A1 Benutzerhandbuch

Operating Instructions

Operating Instructions
Name and Function of Remote Controller
3
Signal Receiver
5
8
9
10
11
12
13
14
1. Operation display
Displays the operation conditions.
2. On/Off Button
Operation starts when this button is pressed, and
stops when the button is pressed again.
3. Set Temperature Button
Used to set the temperature when the desired
temperature is obtained.
4. FAN Operation Button
Used to circulate room air without cooling or
heating.
5. Electric Heater Button(optional)
Used to set the Electric Heater.
6. Fan Speed Button
Used to set desired fan speed.
7. Operation Mode Selection Button
Used to select the operation mode.
• Auto Operation Mode.
• Cooling Operation Mode.
• Soft Dry Operation Mode.
• Heating Operation Mode.(except cooling model)
8. Timer Cancel Button
Used to cancel the timer.
❈ Display temperature can be different from actual room temperature if the remote controller is
installed at the place where sun-rays are falling directly or the place nearby heat source.
8 Multi Type Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED
Room Temp
HI
MED
LO
Time
ZONE
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17
Timer Cancel
Program Week Holiday
Plasma
SET/CLR
Hour Min
RESET
9. Timer Set Button
Used to set the timer when the desired time is
obtained.
10. Week Button
Used to set a day of the week.
11. Program Button
Used to set the weekly timer.
12. Holiday Button
Used to set a holiday of the week.
13. Time Set Button
Used to set the time of the day and change the
time in the weekly timer Function.
14. Set and Clear Button
Used to set and clear the weekly timer.
15. Room Temperature Checking Button
Used to check the room temperature.
16. Plasma Air Clean Button(optional)
17. Reset Button
Used to set the current time and clear the setting
time.
SUB FUNCTION
AUTO Heater Preheat
JET Defrost Humidify
Filter Out door
1 2 3 4
19 21 23
1
2
6
7
4
15
16
17