Drill The Pilot Hole(S), Using An Electric Drill With An - StarTech FPWTLTB1 Installationsanleitung

Locate the center of the Wood Stud(s), using an Electronic
2.
Stud Finder. Mark the location of the Edges and Center of
the Stud(s), using a Pencil.
Hold the Mount or Mount Template in the desired location,
3.
to ensure the Mounting Holes align with the center of the
Wood Stud(s). In addition, ensure the Mount is level, using
a Spirit/Bubble Level. Use a Pencil to mark the intended
location(s) of the Pilot Hole(s).
Remove the Mount from the target mounting location.
4.
Scan the intended Mounting Location for Live Wires, using
5.
a Stud Finder with AC Current Detection. Mark the location
of any live wires, using a Pencil.
Locate the Electrical Service Panel and switch all applicable
6.
breakers to the OFF position.

Drill the Pilot Hole(s), using an Electric Drill with an

7.
appropriately sized Drill Bit. The depth of the holes should
equal the length of the Mounting Screws.
Note: Stop drilling if significant resistance is encountered.
Drill the remaining pilot holes in alternate locations.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
4