Clear A Scene Or Scenes; Delete A Step Or Steps; Insert A Step Or Steps - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

Clear a scene or scenes

1 Enable Program mode.
2 Record a scene or scenes.
3 If you are not satisfied with the scene or scenes, you may tap the REC CLEAR button while pressing and
holding the RECORD button. All LEDs will flash, indicating the scenes have been cleared.

Delete a step or steps

1 Enable Program mode.
2 Tap the STEP button to scroll to the step you wish to delete.
3 Tap the DELETE button when you reach the step you wish to delete. All LEDs will flash briefly indicating the
deletion of the step.
4 Continue steps 2 and 3 until all the unwanted steps have been deleted.
5 Tap the REC EXIT button while pressing and holding down the RECORD button. The scene LED goes out,
indicating the exit of Edit mode.
.
EXAMPLE
Delete the 3rd step of the program on Flash button 25 on Page 2.
1 Enable Program mode.
2 Tap the MODE SELECT button to select CHASE/SCENES mode.
3 Tap the PAGE button until Page 2 LED lights.
4 Tap the FLASH button 25 while pressing and down the EDIT button. The scene LED lights.
5 Tap the STEP button to scroll to the third step.
6 Tap the DELETE button to delete the step.
7 Tap the REC EXIT button while pressing and holding down the RECORD button to exit Edit mode.

Insert a step or steps

1 Record a scene or scenes you wish to insert.
2 Be sure you're in CHASE/SCENES mode. Then enter the Edit mode.
3 Tap the STEP button to scroll to the step which you wish to insert before. You may read the step from the
display.
4 Tap the INSERT button to insert the step you've created. All LEDs will flash, indicating the step is inserted.
5 Tap the REC EXIT button while pressing and holding down the RECORD button. The scene LED goes out,
indicating the exit of Edit mode.
.
EXAMPLE
Insert a step with channels 1-12 fully on at a time between step 4 and 5 of program 35.
1 Enable Program mode.
2 Push Channel faders 1-12 to the top and record the scene as a step.
3 Tap the MODE SELECT button to select CHASE/SCENES mode.
Tap the PAGE button until Page 2 LED lights.
4
Tap the FLASH button 35 while holding down the EDIT button, the corresponding scene LED lights.
5
6 Tap the STEP button to scroll to the step 4.
7 Tap the INSERT button to insert the scene you've created before.
27 • EN