Working Instructions; Reventive Maintenance - SUHNER ABRASIVE LSG 16 Originalbetriebsanleitung

3.1.1 c /f
hAnging itting the tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
3.2 w
orKing instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
4. S
ERvICE
4.1 P

reVentiVe mAintenAnce

Without a tool clamped in check no-load
speed periodically and after each mainte-
nance. Even if the machine still operates
perfectly, the motor should be removed, cleaned and the
four slides checked for wear by a specialist after approx.
300 to 400 operating hours.
4.1.1 r
ePlAcement of the exhAust Air hose
Detach the exhaust air hose from the swivel ring, and re-
place it.
/ m
aINTENaNCE
4.1.2 r
ePlAcement of the suPPly hose
Remove the exhaust air hose (see 4.1.1).
Detach the hose clip, and pull the supply hose off the
connection nipple.
17