Hilti SIW 22T-A 1/2 Bedienungsanleitung Seite 26

7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The tool doesn't work.
The tool doesn't work – 1
LED blinks.
The tool doesn't work – 4
LEDs blink.
The control switch cannot be
pressed.
Speed of rotation drops con-
siderably.
The battery is not heard to
engage.
The battery runs low more
quickly than usual.
The tool or the battery gets
very hot.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
20 English
Possible cause
The battery is not correctly in-
serted.
1 LED flashes: The battery is
empty.
The battery is too hot or too cold.
The power tool was overloaded
briefly.
The forward / reverse selector
switch is in the middle position.
Low battery.
The retaining lugs on the battery
are dirty.
Very low ambient temperature.
The tool is overloaded (application
limits exceeded).
Action to be taken
▶ Insert the battery. → page 17
▶ Charge the battery. → page 17
▶ Allow the battery to cool down
/ warm up to its working
temperature.
▶ Release the control switch and
then press it again.
▶ Set the forward / reverse
selector switch to forward or
reverse rotation. → page 18
▶ Charge the battery. → page 17
▶ Clean the retaining lugs.
▶ Warm up the battery slowly to
room temperature.
▶ Select a product that is suitable
for the intended purpose.
408163
*408163*