Hilti SIW 22T-A 1/2 Bedienungsanleitung Seite 24

2. Remove the battery from the tool.
5.1.4 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others. Check that the belt hook is fitted
securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
1. Disconnect the battery from the tool.
2. Fit the mounting plate into the guides provided.
3. Use the 2 screws to attach the belt hook and make sure that the screws are driven fully (countersunk
head flush).
5.1.5 Setting forward or reverse rotation
In the middle position, the forward / reverse selector switch serves as a safety lock.
▶ Set the forward / reverse selector switch to forward or reverse rotation.
5.1.6 Installing an accessory tool
1
SIW 22T-A / "
2
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Line up the hole in the accessory tool with the half ball in the square drive spindle.
3. Push the accessory tool on to the product's square drive spindle.
▶ The accessory tool snaps into engagement.
5.1.7 Removing the accessory tool
1
SIW 22T-A / "
2
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the accessory tool off the square drive spindle.
5.1.8 Installing an accessory tool
3
SIW 22T-A / "
4
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Remove the O-ring from the groove in the accessory tool.
3. Pull out the locking pin.
4. Set the O-ring on the product's square drive spindle.
18 English
2
3
4
5
6
408163
*408163*