Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Important safety issues
17. When a set period of time has passed after setting the mode, the internal projector will
move automatically. Lie down in the correct posture.
18. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order ti avoid a hazard.
Notice to users
This product complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this product may not cause harmful interference, and (2) this product
must accept any interference received, including interference that may cause undesired
operation.
NOTE: This product has been tested and found to comply with the limit for a Class B
digital product, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equ-
ipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular
installation, which can be determined by turning the product off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
- Connect the product into an outlet on a circuit different from that to which the
receiver is connected.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the product.
Caution
4
C o n t e n t s
>> Important safety issues
- Danger
- Warning
- Caution
Ⅰ. Introduction of the product
1. Product's characteristics
2. The name of each part
Ⅱ. Installation and preparation
1. Check product's Composition
2. Check before product installation
3. Installation
4. Check after installation
Ⅲ. Using the product
1. Check before using the product
2. Remote control layout
3. How to use the remote control
4. How to move the product
Ⅳ. Management and matters that require attention
1. Self inspection
2. Management techniques and storage methods
3. Check before A/S request
4. Diagnosis code message
5. Product specifications
6. Product warranty
01
07
11
16
37
5
Werbung
Inhaltsverzeichnis
