Blaupunkt ESC90X Bedienungsanleitung Seite 9

ESC90X
A. Lift the handlebar stem to the upright position.
B. Lock the folding device by moving the key up as far as possible, and secure the key against
unlocking.
C. Connect the plugs of the wires prominent from the handlebar and the stem, and then assemble
the handlebar by properly inserting it into the upper part of the stem.
D. Use the wrench to tighten all the screws securing the handlebar to the stem. Adjust and tighten
the brake lever accordingly.
E. To eliminate the clearance in the scooter's folding device with the wrench, adjust the tightening
of the screw at the front of the device. When using the scooter, check the tightness of the screws
regularly.
2. Handlebar disassembly for transporting.
A. Use the wrench to unscrew the screws securing the handlebar.
B. Unscrew the nut adjusting the brake cable, then gently press the brake lever and remove the
cable from the lever.
C. Gently lift the handlebar upwards to remove it from the stem. Remember that there is a cable
connecting the controller to the display inside, so do not lift the handlebar with excessive force.
D. Gently disconnect the cable plug between the handlebar and the stem.
7