Blaupunkt ESC90X Bedienungsanleitung Seite 12

ESC90X
• Make sure that the electrical outlet is dry.
• When charging the scooter-mounted battery, open the cover of the battery-charging socket
located in the lower part of the battery housing. When charging the disassembled battery, the
charger is plugged into the same socket.
• Plug the adapter plug into the power source (110 V ~ 240 V, 50 Hz ~ 60 Hz), make sure the green
charging lamp is lit, insert the other adapter plug into the scooter's charging socket.
• When the red LED on the power supply lights up, the battery is charging correctly, otherwise
check all cable connections.
• When the red light turns green, the battery is fully charged. Disconnect the power supply from the
power source. Long-lasting charging can shorten battery life.
• Follow the instructions for charging the battery, otherwise it will damage the battery and shorten
its service life.
• The time to charge the scooter's battery is about 6 hours. The manufacturer cannot guarantee the
same charging time and operation of the battery due to its wear.
• Ensure clean and dry conditions when charging the battery.
• Do not charge the battery when the power outlet is wet.
First run
Preparation
• Select the desired location. This place can be inside or outside, it must have an area of 10 x 10
meters (about 100 square meters). The place should be flat, neither wet nor slippery, without
obstacles, without vehicles, children, pets or any other things that could distract your attention.
• Read this manual carefully, if you have the opportunity to do so, for advice from a person who is
more experienced in safe driving.
• Wear helmet and protectors to avoid possible injuries. Move the scooter to the center of the area
where you will be moving and familiarize yourself with the area.
Start
• Press and hold the POWER push button for 2 seconds to switch the scooter on, then select one of
the three speed modes
• Place one foot on the deck plate and with the other foot kick-start the scooter
• Place the other leg on the deck plate and ensure you keep your balance
• Press the thumb throttle with your right thumb, and do not ride too fast
• Squeeze the brake lever with your left hand to brake, and gently press the rear fender to assist the
braking
• You can get off the scooter when it is running at a low speed or after it has come to a complete stop
• To warn other users that you are nearby, use the bell fitted next to the brake lever
The BLAUPUNKT E-Mobility mobile app
This electric scooter works with the dedicated BLAUPUNKT E-Mobility app. This app allows you to
control many parameters of the scooter, such as distance travelled, battery consumption, and
current speed. It is also possible to check your current position on the map.
The app can be downloaded from the appropriate store for the operating system i.e. Play Store for
Android and AppStore for iOS.
After downloading the app and installing it on your smartphone, connect it to your scooter
following these instructions.
1. Start the scooter and then turn on the Bluetooth module in your mobile device.
2. Open the Blaupunkt E-Mobility app and press the Bluetooth icon to search for available devices.
3. When the name "BP ESC90X" appears on the list of available devices, press it to connect.
4. If a password is needed, enter 000000 (6 zeros)
5. After the scooter is correctly connected to the application, you can make changes to the scooter
settings.
Electric lock
The electric lock is one of the functions available in the BLAUPUNKT E-Mobility mobile app. Once
the lock is activated from the app level, it is impossible to continue riding the scooter. The scooter
can be started but the acceleration function does not work. Only after the lock has been
deactivated in the app, you can continue riding the scooter.
10