BOMANN EBO 7909 IX Bedienungsanleitung, Garantie Seite 27

Temperature control lamp
The control lamp indicates heating operation.
If the light goes out, the set oven temperature has
been reached.
During operation, the oven must be reheated again
and again to maintain the set temperature. During re-
heating, the control lamp lights up (thermostat func-
tion).
NOTE:
If the recipe recommends placing the food in the pre-
heated oven, this should not be done before the con-
trol light first goes out.
Digital timer with LED display
The display is used to set the time and the various
functions of the timer. Use the buttons
make the settings.
Control lamps
1 Auto mode 3 Minute minder (alarm)
2 Manual mode 4 Second dot symbol
Function buttons
NOTE: Touch Control
• The buttons respond to a light touch. You do not
need to apply pressure.
• The unit responds best when the buttons are
touched with the tip of your finger.
Decrease time setting
Manual mode
Settings: system time / timer functions
Increase time setting
(setting signal tone volume)
Switching on
After connecting to the power supply, the display
[00•00] appears and the symbol (4) flashes:
- first select the beep volume
- and then set the time of day (system time) to put
the appliance into operation.
Setting the signal tone volume
You have the option of selecting 3 volume levels.
• While the dot symbol (4) is flashing, you can se-
lect the volume level using the
Setting the system time
Set the current time of day:
• Keep pressing the button
and to
about 3 seconds to set the time of day. The sym-
bol (2) for manual mode lights up.
• While dot symbol (4) flashes between hour and
minute, you can make the setting with the buttons
and
Manual mode
Operation without setting timer functions.
• Keep pressing the button
about 3 seconds to start operation. While the
symbol (2) is flashing, manual operation is acti-
vated.
• The oven is equipped with various functions, see
"Oven functions"
ditions.
-
Turn function selector control to position.
-
Turn temperature selector control to position.
End of manual operation
• To switch off the oven, turn both controls back to
the off position.
• To prevent unintentional operation, hide the oven
selector controls in the control panel → only possi-
ble if the controls are in the off position!
27
for manual mode for
.
for manual mode for
. Set the required operating con-
button.