Transmission Test - Danfoss 088U0210 Benutzerinstruktion

Instruction CF-RS Standard Room Thermostat
Select output on Master Controller
• All available output LEDs on Master Controller
light up, and the fi rst of them fl ashes
• Press output selection button
output (fl ashes) and accept with OK
• All output LEDs
stays ON shortly
Room Thermostat installation status
• Satisfactory - LED
• Not satisfactory - LED
Note: A Room Thermostat can be assigned to
several outputs if needed

3. Transmission Test

Initiate transmission test on Room
Thermostat - fi g. 1
• Press the push button
• LED goes ON
Link test is satisfactory
• LED goes OFF
6 VI.UH.L3.80
go OFF. Selected output
goes OFF
fl ashes 5 times
Produced by Danfoss Floor Heating Hydronics 01.2006
, select desired