IKEA UPPSPEL AA-2298894-2 Bedienungsanleitung Seite 6

Reset process:
Step 1: Press/hold the down button for a few seconds until the table reaches
its lowest position.
Step 2: Press/hold the down button a second time until the display shows
"RST".
Step 3: Press/hold the down button a third time until the table slowly lowers.
Once the table stops moving and the display shows "72", your desk is ready to
use.
Lock/Unlock controller:
Lock the controller: Press and hold the
display shows "LOC".
Unlock the controller: Press and hold the
display shows the actual height of the table.
Highest /lowest limit setting
1. To save the current height as the highest limit:
Step 1: Press the button , the display will show "S-".
Step 2: Press arrow up button until the display flashes.
Step 3: Press the button again, the highest limit setting is completed when
the display shows "999".
Error Code Instructions
Error Code Reason
E01 Overcurrent protection/short circuit
E02
E07 Motor line open circuit error
E08
E13 Overcurrent protection/short Circuit
H01 Over-heating
RST Power failure
888/000 Controller error
The crossed-out wheeled bin symbol indicates that the item should be disposed
of separately from household waste. The item should be handed in for recycling
in accordance with local environmental regulations for waste disposal. By
separating a marked item from household waste, you will help reduce the
volume of waste sent to incinerators or land-fills and minimise any potential
negative impact on human health and the environment. For more information,
please contact your IKEA store.
6
symbol for 10 seconds until the
symbol for 10 seconds until the
2. To save this current height as the lowest limit:
Step 1: Press the button , the display will show "S-".
Step 2: Press
arrow down button until the display flashes.
Step 3: Press the button again, the lowest limit setting is completed when
the display shows "000".
3. To cancel the limits:
Step 1: Press the button , the display will show "S-".
Step 2: Press the button again, the limit setting is canceled/removed when
the display shows "555".
Adjust the Minimum height
1. Follow RESET process, go to the reset situation, it shows RST.
2. Press for 5 seconds, the screen shows height and flashes
3. Then, press or to adjust the height to what you need, and wait for 5
seconds, the screen displays RST, successfully adjust.
Solution
Remove the excess load on the desk first. Then, see instructions for
Reset/Initialisation.
Make sure all the cables connect well first.
Then, see instructions for Reset/Initialisation.
See instructions for Reset/Initialisation.
Unplug from the wall socket and re-plug – or wait 18 minutes to let the
motors cool before using them again.
See instructions for Reset/Initialisation.
Please contact IKEA Customer Service.