BOMANN DU 7608 Bedienungsanleitung, Garantie Seite 43

Fig. 4
 Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 9x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting [Fig. 1].
Insert the supplied dowels.
 First, drill the holes for attaching the housing ac-
cording to the enclosed drilling template. Check
the markings with a spirit level!
Fasten the bracket (01) for suspending the
-
housing with the 3x ST4*40mm screws.
 Fix the bracket (02) for the upper shaft closure
with the screws 2x ST4*40mm; after determining
the extension length of the shaft cover.
 Before attaching the housing, insert the non-
return valves by lightly bending them from above
into the connecting piece (extraction duct) [Fig. 2].
For exhaust mode:
Hereupon a flexible exhaust hose
(included in delivery) with 150 mm inner diameter
must be attached. Secure the hose with the cable tie
[Fig. 2a].
 Hang up the housing [Fig. 3]. Check the secure
hold and the horizontal position.
 Secure the housing with the screws
2x ST4*30mm through the housing [Fig. 4].
 Fasten the outer (lower) shaft with the bracket
(03) using the 2x ST4*8mm self-tapping screws
[Fig. 5].
For exhaust mode:
Check the correct position of the
exhaust hose and connect it with the outlet opening.
Fig. 5 Fig. 6
 Put on the telescoped shaft unit [Fig. 6] and tight-
en the middle bracket (03) with the screws 2x
ST4*40mm.
 Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm [Fig. 7].
Installing the activated carbon filter for recirculation
mode
 Remove the aluminum grease filter(s) (see
"Cleaning the aluminum grease filter"
 Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter.
 Reinstall the aluminum grease filter(s).
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
43
Fig. 7
).
Turn the filter clockwise
until it clicks into place.