Chamberlain 747REV Bedienungsanleitung Seite 9

CAUTION
Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 1.5 m, and
away from all moving parts of door.
FEATURES
For use with Chamberlain garage door openers.
Personalized Password:
Up to 10,000 possible combinations. Password can be easily changed if desired.
Temporary Password:
Can be added for visitors or service persons. This temporary password can be limited to a programmable number of
hours or a programmable number of entries.
Rolling Code: While your password remains constant until you change it, the code between the Keyless Entry and the
receiver changes with each use, randomly accessing over 100 billion new codes.
Operation: Opener activates when 4-digit password and ENTER button is pressed. If wrong numbers are accidentally
pressed, correction can be made immediately. The ENTER button will transmit only the lastfour digits. The keypad will
blink for 15 seconds after the password is transmitted. During that time the ENTER button can be used to stop or reverse
the door travel.
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been
activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1
and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times
when one button close is deactivated.
SETTING THE PERSONAL ENTRY PASSWORD
We recommend that you program your password now, before you install the Keyless Entry. Then you can test the reception
at the mounting location before you proceed further.
USING THE "LEARN" BUTTON (FIG. 1,2,3)
1. Press and release the learn button on motor unit. The learn indicator light will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit personal identifi cation number (PIN) of your choice on the keypad. Then press
and hold the ENTER button.
3. Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks
will be heard.
INSTALLATION (FIG. 4)
Choose a convenient location for installation. Install out of the reach of children at a minimum height of 1.5 m, away from all
moving parts of door. For a one-piece door, choose the optional location shown in the illustration to avoid injury as the door
swings up and out. Test the reception of the Keyless Entry by operating your opener from the selected location. Change the
location if necessary. Remove the battery cover to access the bottom mounting hole.
• Insert a small phillips screw driver into the small hole at the bottom of the cover and gently pull outward to loosen.
• Slide the cover down to remove. Remove battery.
Center the keypad at eye level against the selected location. Mark 4- 1/4" (10.8 cm) up the centerline from the bottom and
drill a 1/8" (3.2 mm) pilot hole. Install top mounting screw, allowing 1/8" (3.2 mm) to protrude above surface. Position keypad
on screw head and adjust for snug fit. With cover open so bottom mounting hole is visible, use a punch to mark hole.
Remove keypad and drill 1/8" (3.2 mm) pilot hole. Replace keypad and complete installation with bottom screw, using care
to avoid cracking plastic housing. Do not over tighten. To replace battery cover slide up and snap it into place.
THE KEYLESS ENTRY BATTERY (FIG. 5)
To prevent possible SERIOUS INJURY or DEATH: NEVER allow small children near batteries.
If battery is swallowed, immediately notify doctor.
The battery should produce power for at least one year. Replace when the Keyless Entry illumination becomes dim or it
doesn't stay on after a keystroke. Dispose of old battery properly.
7
en