Chamberlain 747REV Bedienungsanleitung Seite 10

TO CHANGE AN EXISTING, KNOWN PIN
If the existing PIN is known, it may be changed by one person without
using a ladder.
1. Press the four buttons for the present PIN, then press and hold the # button. The opener light will blink twice. Release
the # button.
2. Press the new 4-digit PIN you have chosen, then press ENTER. The motor unit lights will blink once when the PIN has
been learned. Test by pressing the new PIN, then press ENTER. The door should move.
TO SET A TEMPORARY PIN
You may authorize access by visitors or service people with a temporary 4-digit PIN. After a programmed number of hours
or number of accesses, this temporary PIN expires and will no longer open the door. It can be used to close the door even
after it has expired. To set a temporary
PIN:
1. Press the four buttons for your personal entry PIN (not the last temporary PIN), then press and hold the * button. The
opener light will blink three times. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then press ENTER. The opener light will blink four times.
3. To set the number of hours this temporary PIN will work, press the number of hours (up to 255), then press *.
OR
3. To set the number of times this temporary PIN will work, press the number of times (up to 255), then press #. The ope-
ner light will blink once when the temporary PIN has been learned. Test by pressing the four buttons for the temporary
PIN, then press Enter. The door should move. If the temporary PIN was set to a certain number of openings, remember
that the test has used up one opening.To clear the temporary password, repeat steps 1-3, setting the number of hours
or times to 0 in step 3.
SPECIAL NOTE: The temporary password can ONLY be programmed to keypads working on a Chamberlain Garage
Door Opener. It WILL NOT work on keypads programmed to an external receiver. The temporary password will continue to
CLOSE the door even after the time has expired. To eliminate this, program a new temporary password into the keypad.
Specifications
Frequency
Transmitting power
Battery
DISPOSAL:
Our electrical and electronic equipment may not be disposed of with household waste and must be disposed
of after use properly in accordance with WEEE Directive EU: 2012/19/EU; GB UK(NI): SI 2012 nr. 19 on waste
electrical and electronic equipment in order to ensure that materials are recycled. Collecting waste electrical
equipment separately means environmentally-friendly disposal and is completely free of charge for the consumer.
WEEE reg. no. in Germany: DE66256568.
Any waste packaging left over with the end consumer must be collected separately from mixed waste, in accordance with
the Directive. Packaging may not be disposed of with household waste, organic waste or in nature. Packaging material
must be separated according to its material and disposed of in the recycling containers provided and in certain council
recycling bins.
Our batteries are marketed in compliance with the law. The 'crossed-out waste bin' indicates that batteries may
not be disposed of with household waste. Batteries included in the product (technical data). In order to avoid
causing harm to the environment or people's health, used batteries must be returned for regulated disposal at
council recycling centres or via retail outlets, as is prescribed by law. Batteries may only be brought for disposal once fully
discharged and, in the case of lithium batteries, with their terminals taped over. The batteries can be easily removed from
our equipment for disposal.
Registration number in Germany: 21002670.
Hereby, Chamberlain GmbH declares that the radio equipment type 747REV is in compliance with Directive 2014/53/EU,
2014/30/EU, 2014/35/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://doc.chamberlain.de/
433.30MHz, 433.92MHz, 434.54MHz
8
< 10mW
9V DC