Flex XFE 15 125 18.0-EC Originalbetriebsanleitung Seite 16

This power tool is intended to function as a

polisher. Read all safety warnings, instruc-
tions, illustrations and specifications
provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury.
Operations such as grinding, sanding,

wire brushing, or cutting-off are not
recommended to be performed with this
power tool.
Operations for which the power tool
was not designed may create a hazard
and cause personal injury.
Do not use accessories which are not

specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory must be

at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness of

your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
Threaded mounting of accessories must

match the grinder spindle thread. For
accessories mounted by flanges, the
arbour hole of the accessory must fit the
locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.
Do not use a damaged accessory. Before

each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute. Damaged accessories will
normally break apart during this test time.
16
XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
Wear personal protective equipment.

Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
must be capable of stopping flying debris
generated by various operations. The dust
mask or respirator must be capable of
filtrating particles generated by your
operation. Prolonged exposure to high
intensity noise may cause hearing loss.
Keep bystanders a safe distance away

from work area. Anyone entering the work
area must wear personal protective
equipment. Fragments of workpiece or of
a broken accessory may fly away and
cause injury beyond immediate area of
operation.
Hold the power tool by the insulated

gripping surfaces when performing an
operation where the tool attachment may
contact hidden power leads. Cutting
accessory contacting a "live" wire may
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
Never lay the power tool down until the

accessory has come to a complete stop.
The spinning accessory may grab the
surface and pull the power tool out of your
control.
Do not run the power tool while carrying it

at your side. Accidental contact with the
spinning accessory could snag your
clothing, pulling the accessory into your
body.
Regularly clean the power tool's air vents.

The motor's fan will draw the dust inside
the housing and excessive accumulation
of powdered metal may cause electrical
hazards.
Do not operate the power tool near

flammable materials. Sparks could ignite
these materials.
Do not use accessories that require liquid

coolants. Using water or other liquid
coolants may result in electrocution or
shock.