Usb/Sd Operation; Bt Mode (10009513 & 10009514 Only); Using External Audio Devices - oneConcept V-12-BT Bedienungsanleitung

EN
34

USB/SD OPERATION

1. Select the USB/SD mode with the FUNCTION SELECTOR and insert a
USB or SD memory device.
2. Use the CD/USB/SD switch button to rotate through CD, USB and SD play
modes. The display will show „USB" or „SD" if the corresponding mode is
active.
3. The repeat, programming, track skip, track search and album functions are
used in the same way as in CD mode.
4. It is not possible to wake up from a USB or SD data medium.
BT MODE (10009513 & 10009514 ONLY)
1. Select BT (BT) with the function selector switch.
2. Select the installation on your BT sending device. The identifier is „V329".
The password is „0000".
3. Wait until the connection is established and play the music.
4. The BT will remember the last connection and it will automatically connect
5. It may cause the music system to be unable to connect to others if there
are too many devices connected together. Please hold PLAY / PAUSE
button for two seconds to clean the memory.

USING EXTERNAL AUDIO DEVICES

You can use it to power external audio devices such as laptops and MP3
players.
1. Slide the cover down.
2. Connect the external audio device to the system.
3. Select AUX with the FUNCTION SELECTOR.
4. Switch on the system.
5. Play music etc. on the external audio device.
6. Set the volume of the external audio device and the system to an adequate
level.
7. Switch off the device after use.