Charging The Rechargeable Battery - BASETech 2372545 Originalbetriebsanleitung

7. Charging the Rechargeable Battery

Observe Chapter "Safety Notes"!
The rechargeable battery must be charged when the drive only turns very slowly without load
or when the drive stops.
Also charge the rechargeable battery every 3 months if you do not need the cordless
screw driver. Otherwise, there may be deep discharge, which will permanently damage the
rechargeable battery. Loss of guarantee/warranty!
The rechargeable battery is discharged when the product is delivered and must be
charged at initial commissioning.
Proceed as follows for recharging the rechargeable battery:
• Connect the large USB A plug of the enclosed USB cable to the corresponding socket of the
charger; ensure proper alignment.
• Plug the small micro-USB plug on the other end of the USB cable into the charging socket (7)
at the bottom of the cordless screwdriver. Observe proper alignment here as well.
• Plug the charger into a mains socket. The charge LED (8) will light up and charging will start.
The charging time is approx. 3 - 5 hours.
The drive motor is off while charging. The cordless screwdriver cannot be used.
• When charging is complete, the charge LED will flash slowly. Now disconnect the cordless
screwdriver from the USB cable, and pull the charger from the mains socket.
Alternatively, the cordless screwdriver can also be charged from a USB charging port
that can provide an output voltage of 5 V/DC and a current of at least 500 mA (e.g.
integrated into some socket strips or similar).
Do not connect the cordless screwdriver to a usual USB port of a computer, however.
32