BDS Maschinen MAB 455 Originalbetriebsanleitung Seite 48

Preparations
KEYLESS quick-change drill chuck system
48
Inserting the tool
Push the KEYLESS quick-change drill chuck system (A) into
‹
the morse taper (3) of the machine.
Connect the lubricant line.
‹
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and insert the tool into the chuck.
NOTE
► Insert the appropriate ejector pin before inserting the core
drill.
WARNING
Risk of injury from incorrectly inserted tool or tool mount-
ing .
► Check by briefly turning the tool whether the collet is en-
gaged.
Removing the tool
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and pull the tool down out of the chuck.
MAB 455