Dispose Of Components; Service - Nicotra Gebhardt RLM 53 Betriebsanleitung

BA-CFD-RLM 9.9 – 05/2021
technical safety as well as health protection were already respected in the development
of our fans. Always observe the applicable country-specific legal regulations with regard
to the disposal of products or waste occurring in the various phases of the life cycle. The
corresponding disposal standards must also be considered.
In the following section you will find recommendations for environmentally friendly
disposal of the machine and its components.
9.1 Disassembly
Disassembly of the product must be performed or supervised by qualified personnel with
the appropriate technical knowledge. The dismantling must be prepared as follows:
 Disconnect the machine from the mains all and remove all cables.
 If necessary, remove all liquids, such as oil and remove this according to the local
requirements.
 Transport the machine to a suitable location for disassembly.
The machine is made up of heavy parts. These can fall during dismantling.
Serious injury and property damage may result. Secure machine parts against
falling before dismantling them.

9.2 Dispose of components

The machine consists mainly of metals. These are generally considered fully recyclable.
Separate the components for recycling into the following categories:

Steel and iron, Aluminium, Non-ferrous metal, Insulating materials, Cables and wires,
Electronic scrap, e.g. circuit boards.
Dispose of electronic components employing the proper procedures for electronic scrap.

10. Service

We offer to all our partners the following services:
 Mobile Customer Service
 Spare Parts Service
EN-14/18
Telephone +49 (0)7942 101 384
Fax +49 (0)7942 101 385
E-Mail service@nicotra-gebhardt.com
www.nicotra-gebhardt.com
English