BWT SL-119-MR Montageanleitung Und Empfehlungen Seite 16

2.5 Fitting the liner
• FIt the liner and insert 2 half pegs in the recesses in the mouth.
• Fill the pool with water.
• The male section should be fitted into both recesses. To ensure this, before mounting the flange, cut the
top part of the liner between the 2 recesses. Push the male section into the recesses.
• Mount the flange and its seal.
• Cut the liner inside the skimmer mouth.
2.6 Finish
Insert the LinerLock tapping gently with a hammer around the entire periphery of the pool. The LinerLock
must be used to ensure perfect leaktightness at the point where the liner is fitted into the locking track.
Purely cosmetic defects that may be found in areas that are concealed once the part is installed have no
impact on the mechanical strength or functionality of the product, and shall not be accepted as grounds
for an exchange
.
16/32
2021/06 - Indice de révision : E - Code : 25110
Hung cut out
Liner cut out
CONSTRUCTION & RÉNOVATION