2.1.2 Installation in a thin wall
2.2
Sealing in the skimmer
Position the mouth flush with the wall
The SS reinforcement is placed on 2 pieces of Hung (just behind the hook section).
Preparation of the skimmer mouth
Clean the entire underside of the skimmer mouth using a rag soaked in a PVC compatible solvant, then
sand it using a rough grain emery paper to improve the adhesion of the fibrous concrete to the ABS surface.
Place the support column in the centre of the skimmer mouth
CONSTRUCTION & RÉNOVATION
Niveau d'eau
Water level
Wasserstand
Livello dell'acqua
2021/06 - Indice de révision : E - Code : 25110
13/32