Installation; Unpacking; Remove The Transport Supports; Cleaning - Electrolux ERES35800 Benutzerinformation

Do not connect the appliance in spaces where ambient temperature can
decrease to below freezing.
The appliance may only be connected to drinking water supplies.
The appliance may only be connected to cold water supplies.

INSTALLATION

Unpacking

Unpack the cabinet and check that it
is in good condition and free of any
transport damage. Notify the dealer
immediately of any damage. Hand the
packaging over for recycling. For more
information, contact your local council
or the dealer.
Do not allow children to play with the
packaging. The plastic film can cause
suffocation.

Remove the transport supports

Remove the tape and the transport
supports from
· the door sides
· inside the door hinges
· the shelves
Remove the transport support on the
glass shelf by pushing the support
forward along the edge of the shelf
until it stops. Take hold of the rear
edge of the glass shelf and pull the
shelf and transport support forward
until the shelf tilts and the transport
support can be removed. Some
models are fitted with a silencing pad
under the cabinet. Do not remove this
pad.
Downloaded from Fridge-Manual.com Manuals
19
All manuals and user guides at all-guides.com

Cleaning

Wash the inside of the cabinet using
lukewarm water, a mild washing-up
detergent and a soft cloth.

Connecting the water hose.

The water coupling is connected to a
water tap with an external 3/4 inch
thread.
This work is to be carried out by a
skilled plumbing installation technician.
The refrigerator is to be connected
with a shut-off cock. There are different
type-approved taps and tap
assemblies on the market.
The water hose must not be cracked,
squeezed or be in tight bends.