Freezing Of Displayed Values (Hold Function); Forming Averages; Retrieving The Average Value; Deleting The Total Memory - Agreto HFM II Benutzerhandbuch

AGRETO HFM II

21.4 Freezing of displayed values (Hold function)

If you cannot see the display while the moisture measurement, for example if
you measure a bale on a trailer, you can freeze the currently displayed moisture
value for 5 seconds by pressing the [Moisture] key. During this time, the current
display is frozen and displayed and the held value is displayed with a non-
flashing decimal point. Then the device starts again with the automatic display
of the current measured value.

21.5 Forming averages

To form an average of several measurements of moisture, or to count the
number of measurements, proceed as follows:
Perform the initial measurement.
When the reading on the display is stable, press the button briefly
[Summing]. The displayed value is written to memory. On the display the
number of measurements that are already in memory appears for 5
seconds. Then the unit will return to the automatic display of the
moisture.
Repeat the process as many times as you like with different
measurements or measurements of several bales.

21.6 Retrieving the average value

To display the average of the stored measurements, proceed as follows:
Press and hold the [Summing] key for about 4 seconds.
The average moisture value of all stored measured values appears on
the display. This value is flashing alternating with the number of
measurements.
The total memory is not cleared.
To return to the current display, press the [Moisture] key.

21.7 Deleting the total memory

To delete the total memory manually turn the device off and on again. After
automatic turn off the total memory is not cleared.
© © © © AGRETO AGRETO electronics GmbH electronics GmbH
AGRETO AGRETO electronics GmbH electronics GmbH
26 26
26 26