Settings; Starting Recording Again When The Full Indicator Lights - Sanyo DSR-M810PA Bedienungsanleitung

2 REC MODE SET

Settings

[MENU] button [ ] button
[ ] button
1
Press the [MENU] button.
The MENU indicator lights, and the <MAIN MENU> screen
appears.
2
Select "2. REC MODE SET", and press
the [ ] button.
The <REC MODE SET> screen appears.
3
Press the [ ] and [
the desired item, then press the [
button.
4
Press the [ ] and [
the setting, then press the [
5
Use the same procedure to set the other
items as needed.
6
Press the [EXIT/OSD] button.
The display returns to the normal screen.
Connecting several digital video recorders to
make series recordings
Use a cable to connect the control terminals as shown in
the following.
1st 2nd
DVR DVR
All manuals and user guides at all-guides.com
[ ] button
[EXIT/OSD] button
] buttons to select
]
] buttons to change
] button.
3rd
DVR
30
Starting recording again when the
FULL indicator lights
When "OVER WRITE" is set to "OFF" and the hard disk
becomes full, the FULL indicator lights and recording stops.
To start recording again, first follow the steps below to
erase the images recorded so far.
[
FULL indicator [
1
Display the <REC MODE SET> screen.
2
Press the [ ] or [
"DISK FULL RESET", then press the
[ ] button.
The <DISK FULL RESET> screen appears with "NO"
flashing.
3
Press the [ ] or [
"YES", then press the [
The images recorded so far are erased, and the display
returns to the normal screen.
The FULL indicator goes out, and you can record until the
disk becomes full.
] button [ ] button
] button
] button to select
] button to select
] button.
English