Husqvarna K 770 Bedienungsanweisung Seite 30

7. Remove the cover on the starter rope handle (A).
A B
8. Pull the starter rope up through the handle (B).
9. Release the knot (C).
10. Remove the starter rope.
11. Make sure that the recoil spring is clean and not
damaged.
12. Put a new starter rope (A) in the hole in the starter
housing.
A
13. Pull the starter rope through the starter rope handle
and make a knot at the end of the starter rope (A).
A
B
14. Attach the cover on the starter rope handle (B).
15. Adjust the tension of the recoil spring. Refer to
adjust the tension of the recoil spring on page 29 .
1447 - 004 - 04.05.2021
C
To
To adjust the tension of the recoil
spring
1. Pull out the starter rope.
2. Hold the starter rope pulley (A) with your thumb.
B
A
C
3. Put the starter rope in the notch (B) and wind it up
around the metal sleeve (C).
4. Pull out the starter rope (A).
A
5. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
B
29