Husqvarna K 770 Bedienungsanweisung Seite 17

the balance in the product and it is more difficult to hold
the product if the cutting blade is pinched or stalled in
the kickback zone. Refer to
WARNING:
is off and that the stop switch is in the STOP
position.
WARNING:
gloves when you assemble the product.
1. Remove the cutting blade, the front belt cover and
the cutting head. Refer to steps 1-5 in
drive belt on page 27 .
2. Remove the 2 screws and nuts that hold the spray
nozzle.
3. Remove the 2 screws from the adjustment handle for
the blade guard.
4. Remove the adjustment handle for the blade guard
16
Kickback on page 17 .
Make sure that the engine
Always use protective
To replace the
5. Remove the stop sleeve.
6. Move the bearing housing and install the stop
sleeve.
7. Install the stop sleeve.
8. Install the drive belt on the opposite side.
9. Install the cutting head and the drive belt cover, refer
To replace the drive belt on page 27 .
to
10. Install the spray nozzle and the cutting blade in the
opposite sequence to how they were removed.
1447 - 004 - 04.05.2021