Maintenance; Maintenance Schedule - Husqvarna K 770 Bedienungsanweisung

4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING:
rope around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION:
rope fully and do not let go of the starter
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
1447 - 004 - 04.05.2021
Do not wind the starter
Do not pull the starter

Maintenance

Read and understand the
rope handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To stop the product
WARNING:
continues to rotate for a while after the
engine stops. Make sure that the cutting
blade can rotate freely until it fully stops. If it
is necessary to stop the cutting blade
quickly, let the cutting blade lightly touch a
hard surface. Risk of serious injury.
• Move the STOP switch to the right to stop the
engine.
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak Discount-equipment.

Maintenance schedule

The maintenance schedule shows the necessary
maintenance of the product. The intervals are calculated
on daily use of the product.
The cutting blade
25