Default Settings; Sensitivity Levels; Reset Modes - Bosch IR LD 1.0 CO2 Bedienungsanleitung

en | 26 | IR LD 1.0 | Operating instructions
CO₂
Fig. 5: Warm up cycle
 The IR LD 1.0 will emit a steady
alarm in synchronization with
the flashing of the center circle
(see Fig. 6).
A
CO₂
Fig. 6: Steady state
"
The IR LD 1.0 is ready to begin
searching for leaks.
SP01502142 | 14.03.2022
i
For optimal performance and
maximum sensitivity, allow
100%
the IR LD 1.0 to operate in
High Sensitivity mode for 5–10
minutes before use.
6.2
After the
warm-up cycle, the
default to High sensitivity and Au-
tomatic reset mode.
6.3
To change the sensitivity level,
press the Sensitivity button (see
Fig. 2; item 6):
¶
Pressing the Sensitivity button
repeatedly will cycle through
the three sensitivity levels (see
Fig. 2; item 6).
i
100%
Sensitivity levels are only
available in Automatic mode.
6.4
The IR LD 1.0 can be set to either
automatically (default) or manual-
ly recalibrate to the ambient level
of refrigerant and reset the alarm
after detection. Both modes al-
low the user to reset the baseline
detection level; which allows for
probing closer to the leak source
without the detector continually
alarming.
Bosch Automotive Service Solutions GmbH

Default settings

completes the
IR LD 1.0
IR LD 1.0

Sensitivity levels

Reset modes

will