Before Initial Use; Start-Up; Using The Hair Curler Attachment - Silvercrest IAN 278219 Bedienungs- Und Sicherheitshinweise

Important safety instructions / Before Initial Use / Start-up
Discontinue use of the hot air
brush it it has been dropped or
otherwise damaged.
Untangle the supply cable
twisted.
Do not use accessories not rec-
ommended by the manufacturer
or offered as accessories.
Repairs may only carried out only
by qualified specialist personnel
or in a workshop approved by
the manufacturer. Improper re-
pairs may result in considerable
danger for the user.

Before Initial Use

Note: Immediately switch off the device if defective
or malfunctions occur.
Note: Hairspray contains flammable substances.
Do not use hairspray whilst operating the hot air
brush.
Wash and groom your hair as usual.
Stand on a dry, non-conductive floor.
Ensure your hands are dry.
Untangle the supply cable
Do not pull, twist or kink the supply cable
and do not run across / place on sharp, pointy
objects or hot surfaces.
Do not crush the supply cable
ers or doors.

Start-up

Towel dry your wet hair and comb it thoroughly.
Allow your hair to dry fully at the roots and
partly along the sections before styling.
Use the styling nozzle
40 GB
if
10
if twisted.
10
,
10
in e.g. draw-
10
to dry the hair.
14
The 40 mm thermal volume brush
ume and fullness to your hair at the roots. The
brush can also be used to style the ends of long
hair and to straighten curls.
First select an attachment
ing on the device. Secure the attachments to
the handle by aligning the dot above the
6
release button on the handle
11
to the left to lock in place.
To change the attachments
release button and turn the attachment to
11
the right.
Insert the mains plug into the socket.
Divide your hair before styling it. First style the
bottom layer of hair.
Select the desired heat and blower setting using
the sliding switch . Select from the following
5
functions:
0 Off
Cool air
1 Medium temperature and airflow
2 High temperature and airflow
Using the hair curler
attachment
Attach the hair roller attachment
dle by aligning the dot above the release
6
button on the handle
11
to lock in place.
Select the desired hair roller size and slide the
hair roller onto the hair roller attachment
13
Press the lock / unlock lever
roller onto the handle (you may need to
13
slightly turn the roller). Release the unlock /
lock lever and the hair roller
2
lock in at the edge.
Take a 2.5 cm wide section of hair and hold it
tautly up or or sideways away from the head.
Continue holding the section of hair taut and
wrap the ends of hair around the self-grip sec-
tion of the hair roller
15
Turn the grip and wrap the hair around the
6
hair roller , not yet switching on the heat
13
function. Be sure the ends are wrapped.
adds vol-
12
, before switch-
12 14
and turn
6
, , press the
12 14
to the han-
1
and turn to the left
6
.
1
and push the
2
will firmly
13
.
13