Setting The Clock; Proceed As Follows; Using Immediate-Start Function - Silvercrest SDG 800 A1 Bedienungsanleitung

points to the front towards the keypad and is
level. Thus, the turbo ring
position.
j 
P lace the food in the steam trays
j 
E nsure that all parts are positioned correctly
before switching on the appliance.
aTTEnTIOn! Never use bowls or other parts,
not especially produced for this appliance.
Otherwise, there may be the risk of injuries
and / or damage of the appliance.
j 
N ow place the steam trays
1 - 2 - 3 succession (please see the markings on
the handles) on top of the condensate collection
basin
7
j 
P lace the cover
steam tray
steam can exhaust.
j 
C onnect the mains plug
j 
T he LC display
Now your steamer is ready for use.

Setting the clock

Q 

Proceed as follows:

j 
S imultaneously press the PROG
OFF 14
will be heard on releasing the buttons.
j 
P ress the PLUS button
indicator
MINUS button
by 1 minute each time.
20
j 
P ress the PROG button
j 
T he LCD-display
clock time (clock time mode).

Using Immediate-Start Function

Q 
note: Consider that the base of the appliance /
water tank
10
up to the MIN mark
in addition to the condensate collection basin
has been correctly positioned.
Downloaded from www.Manualslib.com
will be kept in
8
3
,
3 4
.
centrically so that the upper
1
is completely closed and no
3
to a suitable socket.
18
shows "45" (see Fig. B).
13
17
buttons for 2 - 3 seconds. A signal tone
to increase the time
16
by 10 minutes each time. Press the
20
to reduce the time indicator
16
to confirm your setting.
17
13 will now show the current
has to be filled with water at least
. Ensure that the turbo ring
9
manuals search engine
j 
P ress the ON / OFF button
play
13
of 45 minutes (see fig. B).
j 
, , . P ress the PLUS / MINUS button
4 6
the steaming time in 5-minute steps or decrease
it in 1-minute steps.
note: The maximum steaming time is 90 minutes.
note: Be aware that you might have to replen-
ish water when the steaming time is longer.
Use the openings on the sides of the conden-
, in sate collection basin
6
of the appliance / water tank
the MAX mark
1 hour of steaming.
aTTEnTIOn! HaZarD OF BUrnS!
Make sure that the water does not exceed the
MAX mark
out of the steamer during operation.
j 
P ress the ON / OFF button
a beep. The red indicator light
and the device starts the steaming process.
j 
T he LCD-display
steaming time.
aTTEnTIOn! HaZarD OF BUrnS! The
appliance will become hot during use. Beware
of getting in contact with the ascending steam
and ON / or any components.
j 
I f the set steaming time is elapsed, the appli-
ance will automatically switch back to the
keep-warm mode (see "keep-warm mode").
note: You can increase the steaming time at
any time in 5-minute steps or decrease it in
1-minute steps by pressing the PLUS / MINUS
button
manually to "0", the device switches automati-
cally into the warm mode (see "Warm mode").
aTTEnTIOn! HaZarD OF BUrnS!
Always lift the cover
from you and let the steam exhaust backwards.
Do not bend over the appliance during steam
generation. Use oven cloths when touching the
cover
a long fork or tongs when checking if the food
8
is done.
7
j 
P ress the ON / OFF button
steaming process prematurely or to switch off
Initial Operation
. The LCD dis-
14
will show the factory-set steaming time
16
for refilling. If the base
7
10
, it will be sufficient for approx.
19
. Otherwise, hot water may spurt
19
. The device sounds
14
15
will indicate the remaining
13
. As soon as the steaming time is set
16
slowly, turning away
1
and the steam trays
1 3
to terminate the
14
to increase
is filled up to
comes on
, , . Use
4 6
GB/CY 9