Initial Setup; Use; Setting The Steaming Time - Silvercrest SDD 1600 A1 Bedienungs- Und Sicherheitshinweise

Initial setup

Check and ensure that the mains voltage of
the mains power socket is according to the
"Technical Data" section.
Place the main unit
surface.
Fill the water tank
maximum level (see Fig A and G).
Note: The water tank
with water at least up to the MIN mark
ATTENTION! HOT SURFACE!
Make sure that the water does not
exceed the MAX mark
Otherwise, hot water may spurt out of the
product during operation.
ATTENTION! Do not add anything like
seasonings etc. to the water. This may affect
the steam flow and / or damage the surface
of the water tank
First place the drip tray
, ensure the tongues
12
the slots .
35
Then place the bottom container
inserted dividing plate
.
9
Now place food in the compartment of
bottom container
to ensure food do not mix.
7
If necessary, put the top container
bottom container
compartment of top container
dividing plate
ATTENTION! Never use bowls or other
parts, not especially produced for this
product. Otherwise, there may be the risk of
injuries and / or damage of the product.
32 GB/IE
on a stable, even
12
with cold water to the
10
has to be filled
10
.
15
and the heating element.
10
onto the main unit
9
are aligned with
34
with
8
onto the drip tray
7
. Use the dividing plate
8
6
, place food in the
8
, use the
6
to ensure food do not mix.
5
Place the lid
container
steam can exhaust.
Ensure that all parts are positioned correctly
before switching on the product.
Connect the mains plug to a suitable mains
power socket.
The product will beep and the control panel
will show "00I00" (see Fig. F).
Now the product is ready to use.
. Note: The product will switch off
14
automatically if idled for a minute.

Use

Setting the steaming time

To set the steaming time, press the left menu
button
and select desired food type
relevant food icon (left compartment) / (right
compartment)
will appear.
While the relevant timer
(within 3 seconds), press the increase button
or decrease button
31
steaming time (if necessary).
Repeat above steps for the other
on the
compartment (if required).
Note: The steaming time of each food type can
be adjust between 1 minute and 99 minutes.
Note: In case the steaming time of both left
and right compartments are set to be
different, the compartment with longer
steaming time will start first.
Note: To steam without the dividing plate
/
5 7
and steamed evenly under the same amount
of time. To achieve follow below steps.
centrically so that the top
3
is completely closed and no
6
or right menu button
29
36
/ . The steam icon
19 23
/
20 22
to adjust the
30
, food is recommended to be placed
13
repeatedly
25
– from
41
42
is flashing