Switching On/Off - Westfalia A2S18 Originalanleitung

The revolution in the 1
When L is visible, the 1
nd
H = high = 2
The revolution in the 2
When H is visible, the 2
Do not change the gear while the motor is running! This will lead to
damage to the machine.
 Select low gear L on the gear switch (4) for the higher torque. A
lower speed gear is generally more suitable for driving screws and
fasteners. Low rotation speed is also for drilling into non pre-worked
materials, for mixing paints, or for drilling into ceramics.
 Select high gear H on the gear switch (4) for the lower torque. A
higher speed gear is for drilling in wood, metal and plastics and must
not be used for driving screws and fasteners.
 Always read the documentation provided with drill bits and accesso-
ries for the recommended or maximum speed setting and use the
most appropriate gear. See 'Technical Data' for the maximum no
load speed of each gear.

Switching ON/OFF

WARNING: Always wear adequate personal protection equipment
when setting up and operating this machine.
To start the tool, squeeze the trigger switch (7).
Note: If the trigger switch cannot be pressed down, check that the
forward/reverse switch (6) is not set to its middle position, which locks
the device (see 'Direction Control').
 The speed of the tool is controlled by the movement of the trigger,
the further the trigger switch is pressed down, the faster the tool will
run.
 Release the trigger switch to stop the machine.
st
gear is 0 – 400 min
st
gear is selected.
gear 0 – 1500 min
nd
gear is 0 – 1500 min
nd
gear is selected.
Operation
-1
-1
.
18
.
-1
.