Switching On/Off; Use As Screwdriver; Drilling In Wood, Metal And Plastics - Westfalia A2S18 Originalanleitung

fasteners. Low rotation speed is also for drilling into non pre-worked
materials, for mixing paints, or for drilling into ceramics.
 Select high gear H on the gear switch (4) for the lower torque. A
higher speed gear is for drilling in wood, metal and plastics and must
not be used for driving screws and fasteners.
 Always read the documentation provided with drill bits and accesso-
ries for the recommended or maximum speed setting and use the
most appropriate gear. See 'Technical Data' for the maximum no
load speed of each gear.

Switching ON/OFF

WARNING: Always wear adequate personal protection equipment
when setting up and operating this machine.
To start the tool, squeeze the trigger switch (7).
Note: If the trigger switch cannot be pressed down, check that the
forward/reverse switch (6) is not set to its middle position, which locks
the device (see 'Direction Control').
 The speed of the tool is controlled by the movement of the trigger,
the further the trigger switch is pressed down, the faster the tool will
run.
 Release the trigger switch to stop the machine.

Use as Screwdriver

Note: Always use a universal bit holder when working with screwdriver
bits. Do not mount screwdriver bits directly into the chuck.
1. Select gear L using the gear switch (4).
2. Adjust the cordless drill to the appropriate torque setting (see
'Torque Control').

Drilling in Wood, Metal and Plastics

1. Select the appropriate gear using the gear switch (4).
2. Rotate the torque selector (3) to the drill position icon, which will
provide the highest possible setting.
Operation
25