Turning On/Off; Inserting The Tool Bits - Westfalia 83 65 80 Originalbetriebsanleitung

Turning ON/OFF

1. Press the ON/OFF trigger (6) to start the screwdriver. Release the trigger to
switch off the screwdriver. The rotation speed can be varied by pressing
the ON/OFF trigger. The more the trigger is pressed, the faster the rotation
speed will be.
2. The rotating direction button (5) can only be
pressed when the ON/OFF trigger (6) has
been released. Use the rotating direction
button to switch between clockwise and
counter clockwise rotation. With the rotation
direction button in the central position the
trigger is locked and cannot be pressed.
Use this position before you put down the
screwdriver, to avoid unintentional starting.
3. Important! The screwdriver has to come to a complete stop before the
rotating direction button can be used, otherwise the screwdriver may be
damaged.

Inserting the Tool Bits

Important! Always remove the battery before you change the drill or screw bit
to avoid unintentional starting of the screwdriver.
The cordless drill has a keyless drill chuck (3) so no key is required to lock the
tool bit in place. Make sure that the drill or screw bit is not skewed when it is
inserted and the chuck tightened.
1. Before inserting drill or screw bits
open the jaws of the chuck by
holding the lower ring of the chuck
and turn the locking ring counter
clockwise.
2. Open the chuck until you can insert
the tool.
3. Insert the drill/screw bit all the way
in and then, holding the lower ring,
turn the locking ring clockwise to
tighten it.
4. To remove the tool, hold the lower ring of the chuck and turn the locking
ring counter clockwise. Open the chuck until you can remove the tool.
Operation
12
Lower
Locking Ring
Ring