Westfalia HKS 1400 Originalanleitung Seite 14

 Prop up large panels in order to minimise the risk of a kickback
by a jammed saw blade. Large panels tend to sag under their
own weight. Panels must be supported on both sides, both in
the vicinity of the saw gap as well as on the edge.
 Do not use dull or damaged saw blades. Saw blades with blunt
or misaligned teeth cause increased friction, jamming of the
saw blade and kickback by an excessively narrow saw gap.
Tighten the cutting depth position prior to cutting. If the settings
change while cutting, the saw blade can jam and a kickback
can occur.
 Be especially careful if you perform a "plunge cut" in a hidden
area, such as an existing wall. The protruding saw blade can
get blocked in hidden objects while cutting and cause a kick-
back.
With the device with laser you have purchased a product which
contains a powerful class 2 laser. This laser must be used
responsibly at all times.
For safe operation of the laser please carefully observe the
following safety Notes:
 Read and observe the manual.
 Do not point the laser beam at persons.
 Do not look into the beam or the reflected beam.
 If the laser beam hits your eyes immediately close your eyes
and move your head out of the beam immediately.
 Manipulations (modifications) of the laser device are illegal.
 ATTENTION! Never operate the unit with the housing open!
Safety Notes
DO NOT LOOK INTO THE BEAM
LASER CLASS 2 Acc. to EN 60825-1:2014
10
LASER BEAM