Sony BDX-D1000 Bedienungsanleitung Seite 31

I/Q: Spectrum inputs of the I axis and Q axis (Non-
Invert, Invert, or AUTO). Set to AUTO to
automatically switch according to the input signal.
The setting AUTO is valid only when the above
convolution rate is set to 1/2, 2/3 or 3/4.
C/N: Carrier-to-noise ratio of the signal being
received (for display only)
Indications on the STREAM STATUS menu
The STREAM STATUS menu shows the status of the
program (input stream) being selected.
This menu is for display only. No settings can be
made.
STREAM STATUS
PROGRAM No.
PMT PID
PCR PID
VIDEO PID
AUD1 PID
AUD2 PID
AUD3 PID
AUD4 PID
VBI PID
DATA PID
PROGRAM No.: Program number
PMT PID/PCR PID/VIDEO PID/AUD PID/VBI
PID/DATA PID: Respective packet IDs (in
hexadecimal)
Indications on the TIMING STATUS menu
The TIMING STATUS menu shows the current status
of synchronization.
This menu is for display only. No settings can be
made.
TIMING STATUS
STC 0x03FC42180
VIDEO PTS 0x03FC4208A
AUD1 PTS 0x03FC421A3
AUD2 PTS 0x03FC420CB
AUD3 PTS ---
AUD4 PTS ---
STC: System time clock value (in hexadecimal)
VIDEO: Video presentation time stamp (in
hexadecimal)
AUD1 PTS/AUD2 PTS/AUD3 PTS/AUD4 PTS:
Presentation time stamps of the corresponding
audio channels (in hexadecimal)
200
0x00C8
0x00FE
0x00FF
0x0100
0x0101
---
---
0x0280
0x0300
Indications on the VIDEO STATUS menu
The VIDEO STATUS menu shows the video
compression status of the program being selected.
This menu is for display only. No settings can be
made.
VIDEO STATUS
VIDEO PID
SYSTEM
PROF@LEVEL
BIT RATE
PICT SIZE
ASPECT RATIO 4: 3
VIDEO PID: Packet ID
SYSTEM: 525/59.94 or 625/50
PROF@LEVEL: Compression format (MP@ML or
422P@ML). For Low Delay mode "LOW
DELAY" is displayed on the next line.
BIT RATE: Bit rate (Mbps)
PICT SIZE: Horizontal and vertical pixel counts
ASPECT RATIO: Aspect ratio of the picture (4:3
or 16:9)
Indications on the AUDIO STATUS menu
The AUDIO STATUS menu shows the audio
compression status of the program being selected.
This menu is for display only. No settings can be
made.
AUDIO STATUS
PID 0x0100 0x0101
FREQ 48k
LAYER I
RATE 384k
MODE STEREO STEREO
EMPH ON
PID: Packet ID
FREQ: Sampling frequency (kHz) (48k, 44.1k, or
32k)
LAYER: Layer (I, II, or LPCM = linear PCM)
RATE: Bit rate (kbps)
MODE: Mode (STEREO, JOINT, DUAL, or
SINGLE)
EMPH: Emphasis (ON or OFF)
0x00FF
525/59.94
MP@ML
LOW DELAY
12.1 Mbps
720 x 480
48k
LPCM
128k
OFF
11 (E)