Sony BDX-D1000 Bedienungsanleitung Seite 30

Menu Operations
2
Press the ← or → key.
A setting may now be made for the selected
parameter.
3
Press the ↑ or ↓ key until the desired setting
(value) appears.
If the selected parameter consists of multiple items
(digits), press the → key to move the cursor to the
item (digit) to be set (press the ← key to reverse
the cursor's movement), and input all the items
(digits) in the same manner.
For some items, you must press the ENTER button
for registration.
4
Press the → key when the cursor is located at the
right-most item (digit), or the ← key when the
cursor is located at the left-most item (digit).
You are returned to Parameter selection mode.
Note
The values set in Menu mode are stored in memory
immediately when you end the menu operation.
To leave the Main menu
Press the MENU button in Parameter selection mode
of a submenu.
The menu display disappears, and the unit resumes
normal operation mode.
If you press the MENU button with the Main menu
displayed, the screen display switches to the Monitor
menu (page 14 (E)).
10 (E)
Settings on the PROGRAM SELECT menu
The PROGRAM SELECT menu shows all available
channels.
Press the cursor keys to move the cursor to the desired
channel and press the ENTER button.
PROGRAM SELECT
201< 202
205 206
209
Settings on the TUNER SETTING menu
The general decoding requirements are defined on the
TUNER SETTING menu.
TUNER SETTING
IF FREQ.
FREQ SFT (H) 10853 MHz
FREQ SFT (V) 11108 MHz
LNB PWR(H/V) 11/15
CONV. RATE
SYMBOL RATE
POLARIZATION H
I/Q
C/N
IF FREQ. : Intermediate frequency (MHz)
FREQ SFT (H): Frequency shift for the horizontal
polarization signal at the LNB (low-noise block)
converter (MHz)
FREQ SFT (V): Frequency shift for a vertical
polarization signal at the LNB converter (MHz)
LNB PWR (H/V): Supplied voltages to the LNB
converter for the horizontal and vertical
polarization signals. Select from among 11, 13,
15, 18 V independently for H and V. "OFF" is
displayed when voltage supply is turned off.
CONV. RATE: Convolution rate. Select from
among 1/2, 2/3, 3/4, 4/5, 5/6, 6/7, 7/8, 8/9 and
AUTO. Set to AUTO to automatically switch the
rate according to the input signal.
SYMBOL RATE: Symbol rate (ksps)
POLARIZATION: Select the polarization plane of
the input signal, H (horizontal) or V (vertical).
203 204
207 208
1550 MHz
OFF
3/4
21096 ksps
NON-INV
12.3 dB